Silencer housing made of high-grade titanium
Blue anodised outer sleeve
Rich sound
Low noise level
Easy to mount
Perfect fit
Extremely low weight

Recommended in combination with a FMF Fatty pipe for a perfectly matched full system with optimum performance

DO YOU KNOW that all KTM CNC parts are manufactured from highest quality aluminum and therefore not only look good, they also withstand the toughest treatment? With the anodized aluminum components in the original factory look from the PowerParts range, you can turn your KTM into something very special.

Front brake disc 300mm

No fading
Consistent, high-level braking performance
Perfect dosing capacity
Greater safety in all conditions
Floating
No distortion
No brake juddering
Clear pressure point across the entire temperature range
Inner ring anodised
Outer ring made of stainless high-performance brake steel
Less manual force with the same brake power
Pure race feeling

Made from high grade titanium
Uncompromising race look
Permanently welded brackets
Significantly more performance
Substantial weight saving

Gasgas: To install the silencer, the stock mounting parts must be overtaken.
ATTENTION: When used on EU models from MY26 and US models from MY26 FACTORY EDITION / MY27 Standard, the air box and air filter must be reverted to MY25. The correct engine mapping must also be installed. Vehicles in this configuration no longer comply with the 109 dB FIM noise limit.

Silencer housing made of high-grade titanium
Blue anodised outer sleeve
Rich sound
Low noise level
Easy to mount
Perfect fit
Extremely low weight

Recommended in combination with a FMF Fatty pipe for a perfectly matched full system with optimum performance

Protects the brake disc in the event of a fall
High stiffness and strength
Protects the rear brake disc from stones and other solid obstacles
CNC milled from high-strength aluminum
Lighter than series components
Improved braking performance

CNC milled from high-strength aluminum
Elegant anodised surface

CNC milled from high-strength aluminum
Elegant anodised surface

Uncompromising race look without disruptive passenger footpegs
Mounting at the mounting points of the passenger footpegs
Extremely torsion-resistant
Made of high-quality carbon
Extremely low weight

Same length like the standard pillion footpeg bracket, therefore the mounting point and also the angle of the silencer will stay the same.

Made from high grade titanium
Uncompromising race look
Permanently welded brackets
Complies with current FIM noise regulations
Significantly more performance
Substantial weight saving

Gasgas: To install the silencer, the stock mounting parts must be overtaken.
ATTENTION: When used on EU models from MY26 and US models from MY26 FACTORY EDITION / MY27 Standard, the air box and air filter must be reverted to MY25. The correct engine mapping must also be installed. Vehicles in this configuration no longer comply with the 109 dB FIM noise limit.

CNC milled from high-strength aluminum
Elegant anodised surface

The weight-optimised water pump cover ensures maximum water flow
CNC milled from high-strength aluminum
Elegant anodised surface

No new engine flashing necessarySporty soundStainless steel outer sleeve and interiorUncompromising race lookHighest quality workmanshipLaser-engraved logoPlug & Play mountingKTM specific mesh at the outlet

Extra strong sheet steel
Untreated surface
Full sound
Better power delivery

Combination with FMF silencer recommended

Made of high-quality carbon
Protects the rear brake disc from stones and other solid obstacles

Manifold routing optimally adapted to the production engine
Improved throttle response and increases in both power and torque
Resonator chamber for optimum torque distribution and noise reduction
Highest quality workmanship
Tangible performance boost over the entire engine speed range
Manufactured entirely from high-grade titanium